Pluggy XLR EM272
  • Pluggy XLR EM272
  • Pluggy XLR EM272 with Spring Loaded Mic Holder
  • Pluggy XLR EM272
  • Pluggy XLR EM272 with Windshield to Zoom H4n
  • Pluggy XLR EM272
  • Spring Loaded Mic Holder
  • Pluggy XLR EM272
  • Spring Loaded Mic Holder
  • Pluggy XLR to Zoom H4n Pro via FL101

Pluggy XLR Primo EM272Z1 Microphone

  • High sensitivity Primo EM272Z1 omni-directional low noise microphone
  • Phantom power 12-48 volts
  • Microphone and electronics inside the XLR plug
  • Available as matched Stereo pairs
  • A Pluggy XLR Holder is available.

Primo EM272 data sheet

Capsules: Single
Microphone Holder: without Microphone Holder
In Stock

The Pluggy XLR EM272Z1 uses the acclaimed Primo EM272Z1 capsule, made in Japan. This capsule is extremely low noise (typical 14 dBA self noise) and high sensitivity (-28 dB).

Our own unique electronic design provides a regulated 8 volts to the capsule whether the unit is powered from 12, 24 or 48 volt phantom
Neutrik black metal XLR with gold plated pins
12 volt operation to help increase battery life on portable recorders.
Available as stereo pairs with matched sensitivity

Sound sample Pluggy EM172 vs Sennheiser MKH8020

The EM272 capsule is used extensively by ASMR artists where it's low noise and high sensitivity make it really shine.


Microphone Capsule: Primo EM272Z1
Acoustic Principle: Pressure operated
Directional Pattern: Omni directional

Frequency Range: 20 Hz to 20 kHz

Signal to Noise Ratio: 80 dB at 1 kHz
Self Noise: 14 dB-A

Clipping SPL: 119 dB SPL at 1 kHz
Sensitivity: -28 dB +/- 3dB at 1 kHz
 (0 dB = 1V/Pa)
Dynamic Range: 105 dB
Output Impedance: 1.4 k ohms

Power Requirement: Phantom power, 12-48V

Current Consumption: 0.9 mA

Output Connector: XLR Male, Neutrik, gold plated pins
Dimensions: Length 69 mm, Diameter 21 mm

Accessories available but not included:

Pluggy XLR Foam Windshield


You might also like