Clippy Lyre Stand Mount
£11.00
- Rycote Lyre Mount with 3/8" female thread
- A shock mount holder for the Clippy microphone
- Made from almost indestructible thermoplastic
- Clips firmly around the base of the Clippy
- A Windjammer or Foam Windshield can still be used
Fits all Clippy microphones and others with 7.5–8.5 mm diameter.
The mount holds the Clippy mic very firmly, it needs a good push, starting at a 45 degree angle to insert it.
The Clippy Lyre uses Rycote's established and patented Lyre technology
The adapter is professionally 3D printed in tough nylon and has a steel threaded insert.
The virtually indestructible W-shaped Lyre clip is made of hard-wearing, heat-resistant thermoplastic, and will not perish like elastic suspension systems. It will dramatically reduce the effects of the unwanted vibrations that can reach the mic capsule in undamped mic suspensions and can be heard as noise or low-frequency thumps.
Lyre designed & manufactured by Rycote in Stroud, United Kingdom
Adaptor designed and manufactured by FEL in Sunbury, United Kingdom
Metal 3/8" threaded insert is permanently attached
The Lyre is available separately here.
To use on a camera tripod we have this adapter: FC159 with 1/4" female thread and 3/8" male thread
Overall Height 75 mm
Maximum width 68 mm
Maximum Depth 20 mm
Weight 27 g
62-shore hardness
You might also like
- Rycote Lyre Mount with 3/8" female thread
- A shock mount holder for the Clippy microphone
- Made from almost indestructible thermoplastic
- Clips firmly around the base of the Clippy
- A Windjammer or Foam Windshield can still be used