Primo Microphone Capsules
FC047 Mono Clippy is available. A pair of clip-on lavalier microphones using the superb low noise, high sensitivity Primo EM172 capsules. Rugged black anodised aluminium enclosure, metal grid, tough metal clip and 100cm (200cm when it apart) of thin flexible screened cable. Cable is terminated with a gold 3.5 mm stereo plug.
A clip-on lavalier microphone using the superb low noise, high sensitivity Primo EM172 capsule. Rugged black anodized aluminium enclosure, metal grid, tough metal clip and 1 metre of thin flexible screened cable. To use with a mobile phone you will need a 3.5mm TRS to TRRS Microphone Adapter The Sensitivity Marched Pair Clippy Mono EM172 is available....
High sensitivity omni-directional low noise microphone Balanced XLR output Phantom power 12-48 volts Black aluminium housing Balancing electronics inside the XLR plug Available as matched Stereo pairs and Four matched for surround and ambisonic recording Primo EM172 Data sheet
A complete working microphone module, no soldering required A matched pair of Primo EM272 capsules 1.5 metre screened cable of thin flexible Mogami 2368 to each mic. Metal bodied, gold plated, stereo plug Also available here as a DIY Kit Figure of 8 version is available.
The microphone is not waterproof but it is well protected from physical damage. Mono: 100 cm Stereo: 50 cm Primo EM172 capsule in a rugged nylon panel mount enclosure Designed for outside use in monitoring applications. Include Primo E100 Holder Monacor Windshield and Rycote Windjammer kit are available.
Please note the Primo EM184 capsule is no longer manufactured. The Primo EM264Y with wires are available 5 cm black and red leads soldered to the capsule. We heatsink the capsule before soldering so it is never over-heated. Primo EM172 with wire are available (Low stock) Primo EM184 Clippy Stereo is available (last one)
A collection of parts to make a simple high quality stereo microphone 2 or 4 Matched Primo EM272 capsules Cable 2 pieces thin Mogami 2368, 1.5 metres 1 x Neutrik 3.5mm Stereo Jack Plug (4mm) 10cm of 1.6mm Black Heatshrink Sleeving Figure of 8 cable version is available Complete working microphone module(No soldering required) Direct link: Primo EM172...
This is replacement for the Primo EM172 with wires Ultra low noise | High Sensitivity Wide Dynamic range | Omni Directional 5 cm black and red leads soldered to the capsule Superb quality electret condenser mic capsule, its extraordinarily low noise and high sensitivity makes this ideal for recording nature sounds, backgrounds and ambiences. Primo EM272...
Primo EM264Y Cardioid Microphone Capsule 5 cm black and red leads soldered to the capsule. We heatsink the capsule before soldering so it is never over-heated For general use, low noise and high sensitivity Sensitivity matched pairs and quads are available Alternative to Primo EM184 which is no longer manufactured Comparison table for the Primo Microphones
Omni Directional - Ultra low noise - High Sensitivity - Wide Dynamic range Signal to Noise ratio 80dB (Self Noise 14dBA) Available as single capsules, 2 matched or 4 matched Also available with short wires pre-soldered Sensitivity -28 dB (±3dB at 1kHz, 0dB=1V/Pa) Maximum input Sound Pressure Level 122 dB Comparison Table for Primo Microphone Capsules
Please note the Primo EM173 capsule is no longer manufactured (The last one is available for dispatch). The Primo EM273 close equivalent. Low stock High sensitivity Electret Condenser Microphone Omni directional Ultra low noise Wide dynamic range (108db) 10 mm diameter 3 wire connection Primo EM273 Data sheet Comparison table for the Primo Microphones